top of page
ND_AC_Pedal Lifter_1

Accelerator Pedal Lifter 
ND5RC/NDERC

It is an accelerator pedal lifter that fits Mazda Roadster and Roadster RF.

By raising the pedal by 11mm from the stock pedal, the step between the accelerator and brake pedal is reduced, while the pedal width is expanded by 10mm toward the brake side to achieve reliable heel-toe operation.

Amount of correction

Amount of correction

By increasing the height of the driver's side by 11mm from the position of the genuine accelerator pedal and expanding the pedal width by 10mm, the step and gap with the brake pedal are reduced, realizing comfortable and reliable heel-toe operation.

How to attach

How to attach

Easy and perfect fitting just by putting it on the genuine pedal.

Tighten with M4 x 10mm tapping screws for fixing.

*It is necessary to drill a pilot hole of about 2mm, so please prepare a drill etc.

Fixing screw

Fixing screw

Fix using M4x10mm tapping screws.

Accelerator pedal lifter for Mazda ND Miata and RF.

Although the ND roadster is a perfect sports car, recent safety regulations require a large gap between the accelerator and the brake to provide misapplication. This is not a problem in terms of product safety for everyone, but when heel-and-toe is performed when entering a corner in sports driving, the accelerator pedal may be far away and miss. Therefor, SUBLIME Design Japan has developed a product that can be installed easily and reliably, and can optimize the step between the A/B pedals.

Just by installing this product over the genuine pedal, the pedal will move 11mm closer to the driver from the genuine position.
●It supports smooth corner entry and exit by preventing the accelerator from missing when heel and toe.

●When the foot position is adjusted to the brake, it alleviates the symptom that the knee stretches completely when the accelerator is fully opened, reducing stress.

 

By using PA12GB of the MJF method for the material, high strength and heat durability are secured.


<Wearing method>
1.Remove the genuine accelerator pedal assembly from the vehicle.
2.Temporarily attach the lifter and mark 3 fixing points.

3.Remove the lifter once and drill a 2mm hole at the marking position.
4.Attach the lifter to the genuine accelerator pedal again and fix it with a tapping screw.
5.Complete by attaching the accelerator pedal assembly with the lifter to the vehicle body in the reverse process of removing it.

*Please prepare M4x10mm tapping screw by yourself.
*Be careful not to injure yourself when drilling pilot holes.

*Although we have conducted sufficient tests, we cannot be held responsible for accidents caused by improper installation.
*Be careful not to over-tighten the mounting screws. Over-tightening will damage the plastic parts.

*Specifications are subject to change without notice for product improvement. Please pardon.

Top miata
REV9
bottom of page