Clutch Pedal Extension 20mm
NA / NB Miata / MX-5
*Please use the genuine pedal rubbers.
Clutch pedal extension for Miata, MX-5 (NA/NB).
The driving position can be improved by moving the pedals about 20mm closer to the driver than the genuine one.
Amount of correction
By installing between the clutch pedal lever and the pedal rubber on the vehicle side, the pedal can be brought to the driver side by 20mm.
Installation
For installation, Please slide it so that it covers the clutch pedal lever from the side. After that, use the screw holes on the back of the main unit to fix it to the clutch pedal on the vehicle side. (Be careful not to over-tighten.) It is strongly recommended to use screw locking material when tightening set screw.
Installation screw
The hexagon socket set screws required for mounting are included.
Clutch pedal extension for MAZDA Miata (NA/NB)
Since the angle of the ankle becomes loose, the fatigue of the foot when driving on street roads.
Fine adjustment of the driving position is possible. (Improvement of symptoms such as the clutch being far away when matching the brake)
It facilitates delicate clutch operation such as starting dashes and hand brake turns in sports driving.
<How to install>
1. Remove the genuine rubber pedal cover.
2. Attach the rubber pedal cover to the extender. (We recommended that you prepare a genuine new product if possible)
3. If you screw a hexagon socket set screw into the screw hole on the back side in advance, later work will be easier. (At this time, it is recommended to apply thread lock material in advance)
4. Insert the extension into the clutch lever and tighten the screw fix it.
The material uses MJF method PA12GB to ensure high strength and heat durability.
Also, since it is made very lightweight, there is no adverse effect on the clutch feeling.
*Although we have conducted sufficient tests, we cannot be held responsible for accidents caused by improper installation.
*Be careful not to over-tighten the mounting screws. Over tightening will damage the plastic parts.
*Can be used with screw fasteners for general medium strength metal products.
*Specifications are subject to change without notice for product improvement.
